8100 Inspiron on Slackware9
Hi. I recently installed this version of Linux and both times that I installed it I got the same set of errors that occur around where it initializes the usb devices. It gives different error when it starts up, but the following sort of shows them.
Now I have no clue if what I have there has anything of any use, but let me write out one of the errors from my console.
insmod: /lib/modules/2.4.20/kernel/drivers/char/i
I think when I installed Gentoo it did the same sort of thing. Any clue how I could get around that? :)
uhci.c: USB UHCI at I/O 0xbce0, IRQ 10 usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected i810 TCO timer, v0.05: timer margin: 30 sec (0x0860) (nowayout=0) i810_rng: RNG not detected i810_rng: RNG not detected i810_rng: RNG not detected i810_rng: RNG not detected hub.c: new USB device 00:1f.2-1, assigned address 2 usb.c: USB device 2 (vend/prod 0x45e/0x53) is not claimed by any active driver. i810_rng: RNG not detected i810_rng: RNG not detected i810_rng: RNG not detected hub.c: new USB device 00:1f.2-2, assigned address 3 hub.c: USB hub found hub.c: 4 ports detected i810_rng: RNG not detected i810_rng: RNG not detected hub.c: new USB device 00:1f.2-2.4, assigned address 4 usb.c: USB device 4 (vend/prod 0x451/0xe001) is not claimed by any active driver. i810_rng: RNG not detected i810_rng: RNG not detected i810_rng: RNG not detected i810_rng: RNG not detected i810_rng: RNG not detected usb-uhci.c: $Revision: 1.275 $ time 15:38:38 Mar 11 2003 usb-uhci.c: High bandwidth mode enabled usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
Now I have no clue if what I have there has anything of any use, but let me write out one of the errors from my console.
insmod: /lib/modules/2.4.20/kernel/drivers/char/i
I think when I installed Gentoo it did the same sort of thing. Any clue how I could get around that? :)
