Landee Pipe Fitting is committed to manufacturing of Piping Bend, Cap, Coupling, Elbow, Reducer, Stub End, Tee, Olet, Joint, Gasket, etc. Our mission is to improve the flow control ability of oil, gas, water, steam, acid liquid and other fluid.
Product Name: Carbon Steel Pipe Clamp, Heavy Duty Material: Carbon Steel Size Range: DN200–DN400, 8-16 Inches Surface Treatment: Anti-rust Painting
5.1.1 Evolution of the Flow Field in the Bend The influence of flow velocity on the flow field characteristics within the pipe bend was investigated while the bend diameter ratio and solid particle concentration...
Product Name: Custom Pipe Clamps Type: Pipe Clamp Material: Carbon Steel Size Range: DN25–DN100, 1-4 Inches Surface Treatment: Anti-rust Painting
Abstract: This study investigates pipe perforation and leakage caused by erosion from ammonium chloride crystallization in the top circulation system of heavy-oil catalytic cracking units. By...
Product Name: Rectangular Bellows Expansion Joint Type: Bellows Expansion Joint, Metal Expansion Joint Bellows Material: SS 304 Flanges Material: Carbon Steel Flow Guide Cylinder Material: Carbon Steel...
Abstract: This study investigates the formation of the σ phase in austenitic heat-resistant steel pipe joints used in power plant boilers. Results show that different morphologies of the...
Product Name: Stainless Steel Sanitary Pipe Holders Types: Sanitary Pipe Holder, Bolt Round Pipe Holder, Hexagon Pipe Holder Sizes: 1/2–12 Inch, DN15–DN300 Body Material: Stainless Steel SS...
Abstract: During a scheduled inspection at a petrochemical plant, pitting corrosion was detected in the base material of a TP304 ethylene pipeline elbow. To determine the cause and develop effective...
Product Name: Sanitary Pipe Unions, Stainless Steel Types: Nut, Male, Liner, Expanding Male, Blind Nut Sizes: 1/2–10 Inch, DN15–DN250 Outside Diameter: 17.2–273 mm Standards: DIN, SMS,...
Abstract In a thermal power plant project, small-diameter serpentine heat exchanger tubes were fabricated from 20G steel with dimensions of Ø25 × 3 mm, a bend angle of 180°, and a bend...
