Project Gus

Might even work.

Main menu

Skip to content
  • Home
  • About

Post navigation

← Older posts

Introducing Fakon

Posted on December 22, 2024

(More reverse engineering of parts from a crashed Hyundai Kona Electric, so they can be used in EV conversions.)

Bench Kona with wiring and Fakon hardware

Early efforts at operating the "Bench Kona" were driven from my laptop, but it's now controlled from an embedded system named "Fakon". An early development version is now on GitHub.

Fakon …

Continue reading →

Tagged electric-vehicles, ev-conversion-project, rust | Comments

20 Months with a Framework 13

Posted on November 30, 2024

This is a short follow-up to "18 Months with a Framework 13", about my experiences with a "12th Gen Intel" Framework 13 laptop. A few things mentioned in that post have been improved.

Framework in laptop stand

(The title was supposed to be "19 Months with a Framework 13", but I procrastinated. At least …

Continue reading →

Tagged linux, tools, laptops, framework | Comments

Simplifying the Bench Kona

Posted on October 27, 2024

Oops, just like that and six months goes by! Still, there has been steady progress on simplifying the "Bench Kona" project down to something that could be transplanted into a car.

Smart Key Module

A couple of posts ago I wrote about having to wire up my wrecked Hyundai Kona …

Continue reading →

Tagged electric-vehicles, ev-conversion-project | Comments

18 Months with a Framework 13

Posted on September 16, 2024

I've been using a Framework 13 laptop as my main/only computer for a little over 18 months now.

Framework laptop on my work bench

Someone asked me about it the other day, and I remembered that I've been meaning to write up my experiences.

This is essentially a very personal review. I've broken it down …

Continue reading →

Tagged linux, tools, laptops, framework | Comments

Unremarkable Kona Progress

Posted on April 15, 2024

I've been holding off posting as I haven't had any major breakthroughs with the Kona Electric reversing project. However, I haven't sat totally idle...

On-car testing

Last post the Kona motor started to spin, but without a load attached it was spinning out of control! Even in Neutral, the motor …

Continue reading →

Tagged electric-vehicles, ev-conversion-project | Comments

The motor turns (too much)

Posted on January 08, 2024

(Posting this one a while after it happened, due to holidays.)

This instalment is about the "Bench Kona" I've built in the shed. Behold its questionable integrity:

Mess of Kona components and wires on a bench

Different angle, can also see the motor and the battery

You can see the motor and drive unit stack in the foreground, and the battery pack in the background under some junk. These …

Continue reading →

Tagged electric-vehicles, ev-conversion-project | Comments

Tesla Violating Australian Repair Law?

Posted on November 27, 2023

Last week Tesla open sourced parts of their original Roadster design, and also released all of the service information and diagnostic software. I fear this may violate Australia's new Right to Repair laws, and Tesla may be liable for a $187,800 fine for doing so. Oops?

Possibly it's one …

Continue reading →

Tagged electric-vehicles, culture | Comments

Kona CAN Decoding

Posted on October 19, 2023

Oops, over six month since Part Two! I haven't abandoned either the blog or the EV project, although there have been no shortage of distractions. Slow but steady progress has been happening on two fronts: decoding Kona CAN messages, and building a "Bench Kona" in the shed.

This post is …

Continue reading →

Tagged electric-vehicles, ev-conversion-project | Comments

Mysteries of the Griffin iMate

Posted on April 30, 2023

A vintage keyboard, a mysterious battery, and some questionable 1990s engineering choices...

Keyboard

For five years this classic keyboard has sat in my cupboard:

Apple Extended Keyboard II

This is an Apple Extended Keyboard II, released 1990. This model is praised by keyboard nerds for its "clicky" mechanical ALPS switches and sturdy design.

This …

Continue reading →

Tagged electronics, vintage computers | Comments

Dismantling the Kona

Posted on March 29, 2023

Electric Vehicle Conversion Part Two.

In Part Zero and Part One, I took the long way around on an EV conversion project by purchasing this crashed Hyundai Kona Electric for parts:

Kona in the driveway with bonnet and doors open

Disclaimer

This post series is an incomplete informational account and does not constitute any kind of training or "how …

Continue reading →

Tagged electric-vehicles, ev-conversion-project | Comments

Post navigation

← Older posts

Recent Posts

  • Introducing Fakon
  • 20 Months with a Framework 13
  • Simplifying the Bench Kona
  • 18 Months with a Framework 13
  • Unremarkable Kona Progress

Archives

  • 2024
  • 2023
  • 2022
  • 2017
  • 2015
  • 2014
  • 2013
  • 2012
  • 2011
  • 2010
  • 2009
Find me on the Fediverse: @[email protected]
This site is powered by Pelican and styled with SemLican
Advertisement