RemoteQTH Simple rotator interface V.

Simple rotator interface V.

Universal rotator interfaces with web interface, connectable via wired ethernet and powered via POE.

Update firmware by uploading a .bin file via the web interface
Remote powered by passive POE - need 13,8V to 15V/500mA source, mounted to 35mm DIN rail
Switching between three and two wire azimuthpotentiometer in setup page
Enable preamp and shift op amp in setup page
Local control with CW paddle via 3,5mm stereo jack connector
Galvanically isolated AC or DC motor control, including DC PWM
Working rotator without hardware endstops - replace by two (low/high) software adjustable forbidden zones in end positions
MQTT for integrated to your main ecosystem, typicaly NodeRed
MQTT Wall - web clent shown all topics included
Overlap support, for example 405° range, with rotate to short direction
Usable nearest to rotator, directly on tower, or in hamshack
Status LED while using front panel preset knob (indoor desktop use only)
LED showing fuse failure on main board or POE interface
Three safe stop watchdog - 60 sec after firmware without answer, max 90 sec rotate, max 10 sec without 10 grad azimut change during rotate
Under 11V voltage POE power watchdog
Warm up timer for stable value during setup
Firmware detects the hardware version and displays it in the web interface
Optionaly controlled (via MQTT) by Gyrotator independent hardware based on M5Stack fire Gyrotator
Optional WiFi e-ink display on external hardware from LaskaKit
Support 3D print rotator