Thingino Web Flasher for Ingenic Thingino Flasher

Idle DFU
Do not disconnect the device or navigate away during this operation
Device:
SoC: —
Stage: —
VID:PID: —
Pre-configure before flashing (optional)
Baked into the overlay before writing, entirely in your browser.
Flash a prebuilt thingino release
Advanced: custom SPL / U-Boot

Optional. Supply your own DFU-capable SPL and U-Boot to use for the next Bootstrap instead of the bundled images. Both are required; SoC detection is skipped.

SPL: bundled
U-Boot: bundled
Initializing...

Log

Settings

Flashing backend

Chrome will prompt once to allow local-network access.

Flashing options

About

This page writes thingino firmware to an Ingenic camera over USB.

thingino is free, open-source firmware for Ingenic-based IP cameras.

Flashing firmware can brick a camera.

Hover hints for every control can be switched on in Settings.

Project links

thingino project site Documentation and camera wiki thingino firmware source Telegram group Discord server This flasher's source
Flasher version …

Device Info

No data.

Windows Driver Setup

Windows needs a WinUSB driver installed before the web flasher can communicate with the device. Follow these steps:

  1. If the Ingenic vendor USB driver is installed, remove it first via Device Manager.
  2. Connect the device in USB boot mode.
  3. Download and run Zadig .
  4. In Zadig, select Ingenic USB Boot Device from the dropdown.
  5. Set the target driver to WinUSB and click Install (or Replace Driver).
  6. Return to this page and click Connect Device.
Important: The Ingenic vendor driver (libusb0.sys) is not compatible and must be removed before installing WinUSB via Zadig.

thingino-dfu

WebUSB requires HTTPS (or localhost) and Chrome or Edge.