We turned temperature data into physical movement. 🌡️➡️🎯
DS18B20 → MakerBuddy Rule Engine → SG90 Servo + RGB
The needle automatically moves between 🔵🟢🟡🔴 temperature zones.
Built with connector-based MakerBuddy hardware without traditional programming.
#IoT#STEM
🥚🌡️ Built a Smart Egg Incubator with MakerBuddy using a DHT11 + Relay + 5V bulb.
≤35°C → 💡 Bulb ON
35°C → 💡 Bulb OFF
The automation is created visually through the MakerBuddy Rule Engine — a simple way to teach sensors, conditions & IoT.
#MakerBuddy#STEM#IoT
Built a Soil Moisture Analog Gauge with MakerBuddy 🌱💧
🟠 Moisture < 30 → SG90 = 135° → DRY
🔵 Moisture > 30 → SG90 = 45° → WET
The soil sensor controls the physical gauge automatically using the MakerBuddy Rule Engine - no traditional control code required.
#MakerBuddy
We built a Smart Mouse Trap with MakerBuddy.
HC-SR04 detects an object at <10 cm → Relay ON → 5V motor operates the trap → RGB + buzzer alert → system resets.
The complete automation was created visually using the MakerBuddy Rule Engine — no traditional Arduino coding.
